Some 3D Printed Figures (K9s and Grogu)

Morian Miner · **Joined:** Tue Jun 26, 2007 10:19 am

Here's some of my recent 3D printing projects. First, it's Grogu that is scaled for 1/18. The next two are sitting K9s to go with my Marauder K9 units

2DARK2C · **Joined:** Mon Oct 07, 2013 3:59 pm **Location:** MS

so do you just want my address to send a couple dogs

they look great!

Morian Miner · **Joined:** Tue Jun 26, 2007 10:19 am

2DARK2C wrote:

so do you just want my address to send a couple dogs

they look great!

If you have access to a 3D printer, it’s the file from thingiverse, but under a weird name (think they called it any eastern shepherd). You just have to mess around with the scaling you want.

MarkM · **Joined:** Thu Aug 09, 2007 9:23 pm

These look great. Did you do any post-processing or just print and paint?

Morian Miner · **Joined:** Tue Jun 26, 2007 10:19 am

No post-processing except for rescaling. The files, especially for the dogs, are really well done.

AdrienVeidt · **Joined:** Tue Jun 26, 2007 10:19 am

I'm wondering if a swappable dog's ass mod could be done since the MTF rear legs won't allow that much flexing. Pop out the bottom of the figure at the ball waist joint and pop on the sitting bottom half.

Morian Miner · **Joined:** Tue Jun 26, 2007 10:19 am

AdrienVeidt wrote:

I'm wondering if a swappable dog's ass mod could be done since the MTF rear legs won't allow that much flexing. Pop out the bottom of the figure at the ball waist joint and pop on the sitting bottom half.

Although Solidworks has been temperamental when I’ve messed with stl files, I’m sure you could mod the rear end to take the MTF front end. Not sure how much benefit that would be, though, except giving you a dog that can shake. So far, I’ve been using these guys as display swaps - use the MTF when I want an action pose, then swapping out with the static dogs other times.

Forum rules

Some 3D Printed Figures (K9s and Grogu)

Who is online