Shark Navigator Lift-Away Deluxe NV360 Not Picking Up Dirt? Here’s Why and How To Solve ItEver wonder why your Shark Navigator Lift-Away Deluxe NV360 is not picking up dirt when in use? What should you do if the vacuum is not picking up any debris and dust when cleaning?Here are a few reasons that can lead to this problem, and how to solve it.
Full Dust CupOne of the most common causes of the Shark Navigator Lift Away NV360 not picking up dirt well is perhaps the
dust cup being full. In this way, there is no outlet for the collected dirt.
The dust canister requires emptying regularly for optimized suction. Thus, check your
dust cup frequently, or after every use, to ensure it is not full.
Dirty filtersIf
Shark navigator NV360 filters are dirty or clogged, the device will not be able to collect the debris and dust properly. When it comes to
upright vacuums, it is highly advisable for users to wash the
HEPA filter regularly, and replace it after every two years.
Here are some steps you can follow to clean the HEPA filter:
- Turn off the vacuum and unplug it.
- Remove the filters from the pod.
- Over the trash can, tap the filter to remove the major dust and excess particles that are still sticking on.
- Wash the filters with lukewarm water to completely get rid of all the dirt.
- Keep rinsing the filter under running water until it becomes clear.
- Let the filters air dry completely before reinstalling to the vacuum.
If these steps can not help with the suction power, it’s time for you to replace the filter.
Stuck ObjectIf there is a large particle or object stuck in the air path, it blocks the way and prevents the dirt from getting to the dirt canister. Hence, the
Shark Navigator Lift-away Deluxe NV360 cannot collect the dirt well. This will lead to you spending hours on cleaning without having the surfaces wiped clean properly.
Check Here: Shark NV360If your vacuum cleaner falls into this category, here are some steps you can consider trying to remove the object:
- Using the roller brush, check the bottom of the vacuum to locate the position of the object.
- If the object’s position is still unknown, proceed to check the air pathways like the tubes or the vacuum’s handle. If the object is inside the hoses, pull to detach and simultaneously press the latches to remove the debris.
- If you find the object stuck on the brushroll, you can just clean it carefully to remove the debris while not damaging the brush. However, if the debris is hard to remove, you might consider replacing it for an easier and safer solution.
After checking the device carefully and safely removing the debris, plug in your
blue shark vacuum, turn on, and test over again until you get the desired suction.
Low suctionAnother cause that makes the
shark navigator lift away deluxe NV360 not picking up dirt properly is the low suction. This can be because of the wrong suction power adjustment. Thus, if you find your vacuum cleaner’s suction is low, try to check the power button and ensure it’s in the right setting for the surface. Remember that I is for bare floorings while II is designed for rugs or carpets.
You might as well adjust the suction valve collar on the handle. In this way, you can balance the airflow and make sure the suction is at the required level.
Wrap UpWe hope this article can help you troubleshoot the reasons behind why your vacuum cleaner barely collects any dirt. By knowing the reasons and the corresponding solutions, you will have your machine operating well for another efficient cleaning session.
