Here's some of my recent 3D printing projects. First, it's Grogu that is scaled for 1/18. The next two are sitting K9s to go with my Marauder K9 units
| JoeCustoms.com https://joecustoms.com/forums/ |
|
| Some 3D Printed Figures (K9s and Grogu) https://joecustoms.com/forums/viewtopic.php?f=14&t=48143 |
Page 1 of 1 |
| Author: | Morian Miner [ Sat Jan 23, 2021 2:51 pm ] |
| Post subject: | Some 3D Printed Figures (K9s and Grogu) |
Here's some of my recent 3D printing projects. First, it's Grogu that is scaled for 1/18. The next two are sitting K9s to go with my Marauder K9 units
|
|
| Author: | 2DARK2C [ Sat Jan 23, 2021 4:25 pm ] |
| Post subject: | Re: Some 3D Printed Figures (K9s and Grogu) |
so do you just want my address to send a couple dogs  they look great!
|
|
| Author: | Morian Miner [ Mon Jan 25, 2021 11:31 am ] |
| Post subject: | Re: Some 3D Printed Figures (K9s and Grogu) |
2DARK2C wrote: so do you just want my address to send a couple dogs they look great!If you have access to a 3D printer, it’s the file from thingiverse, but under a weird name (think they called it any eastern shepherd). You just have to mess around with the scaling you want. |
|
| Author: | MarkM [ Mon Jan 25, 2021 11:53 am ] |
| Post subject: | Re: Some 3D Printed Figures (K9s and Grogu) |
These look great. Did you do any post-processing or just print and paint? |
|
| Author: | Morian Miner [ Mon Jan 25, 2021 12:19 pm ] |
| Post subject: | Re: Some 3D Printed Figures (K9s and Grogu) |
No post-processing except for rescaling. The files, especially for the dogs, are really well done. |
|
| Author: | AdrienVeidt [ Fri Jan 29, 2021 4:07 pm ] |
| Post subject: | Re: Some 3D Printed Figures (K9s and Grogu) |
I'm wondering if a swappable dog's ass mod could be done since the MTF rear legs won't allow that much flexing. Pop out the bottom of the figure at the ball waist joint and pop on the sitting bottom half. |
|
| Author: | Morian Miner [ Fri Jan 29, 2021 5:33 pm ] |
| Post subject: | Re: Some 3D Printed Figures (K9s and Grogu) |
AdrienVeidt wrote: I'm wondering if a swappable dog's ass mod could be done since the MTF rear legs won't allow that much flexing. Pop out the bottom of the figure at the ball waist joint and pop on the sitting bottom half. Although Solidworks has been temperamental when I’ve messed with stl files, I’m sure you could mod the rear end to take the MTF front end. Not sure how much benefit that would be, though, except giving you a dog that can shake. So far, I’ve been using these guys as display swaps - use the MTF when I want an action pose, then swapping out with the static dogs other times. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|