Is there a way to....

The best example I can try to describe the question is this. Some of the Star Wars figures are real nice, sans the legs (as we all know). Is there a way to make those legs, or take a pair of articulate legs (most likely a Joe figure) and fit it nicely into the figure. I have tried a couple times but am not getting much luck. I dont know if I need to put some sort of pin through where the leg goes and attack the alt legs to them?


Thanks for the time,
Aegis/Jason

its a difficult process, but basically you need to cut the joints of a joe and the joints of the star wars figure, and sculpt them together using apoxi fix it. but this wont make them as sturdy as they once were, and i would assuem would be more acceptable to break.also consider reinforsing the join with some needles on the inside.

Sorry, I don't know if I understand you correctly...
Do you want let's say 25 th snake eyes legs on a clone body, or is it only the joint itself from the Joe you want to ad to the starwars figure?

Mayby you could dremel the leg sockets on the starwars figure so that the joe leg would fit, then dremel the starwars figures leg so it would slide into the leg piece from the joe, I think that the joes T-hook would fit inside the waist of a starwars figure, you would just have glue it in place.