Does anyone know how to Vac-Metal?

I'm wanting to make a 25th Cobra de Aco and was wondering if anyone knew to to Vac-Metal the head. I saw you had a link for it at one time, but the site is no longer up. Any help in this matter would be greatly appreciated!

I do know that Nova sent a few pieces off to have them professionally done, and it wasn't that expensive.

Either PM him, or maybe he'll see this thread and share the info with everyone.

Chromeus.com I believe. It just takes awhile.

EDITED: correct url provided below by Nova

I've looked into a Do it your self start-up kit...and I'm pretty sure the cost was somthing like $200, just to get up and running....I've prolly spent at least that much with ChrometechUSA, but I'm plenty satisfied with their quality.


http://www.chrometechusa.com/ is the correct address for their sight.


Budget around $5 per part you want chromed....but be sure to give them a call and talk them through what you want to do.

You may want to find a Casting of the Snake Eyes head, rather than sending a Production Head....The Softer plastic in the New figures may not take the Vac-Metal as well as Vintage ARAH parts.

I know they had a difficult time with The Green Accessory pack Visors I sent them and then used on Cross and The Veteran

For figures like my Cobra Mortal and Glenda I think I only paid about $3 per part...but they have a total of 12 seperate parts that I had chromed.

Thanks! You guys are awesome! I'll check into it first thing in the morning!