What heads might work with MLS Juggernaut?

I am trying to make a custom using this body, but I would like to swap out the oh so distinctive Juggernaut head.

Any suggestions on heads with compatible scales and neck ball sizes that I might be able to use with the MLS Juggie?

- C

Just about anything Raps.

If it's a socket (25th style) Just put a little ball of epoxy in there and shove the neck post up until it sits where you want it. Remove and trim the excess that's squirted out. Let harden and viola'!

If it's a post (Or a socket with a too small neckhole) cut off the neck at the hair and jaw lines. Then take a set of drill bits and find one that snugly fits into Juggernaut's socket. One you've got that size, pick a smaller one, drill a pilot hole, then drill to correct size. It make take some trial and error, but before long you'll get it to sit where you want it. If it get's too big throw some epoxy in there.

Or you can use a dremel

I think you're going to have a hard time finding something stock that will look in good proportion to the Juggernaut body. Maybe look at some of the knock-off stuff that has whackier proportions like the Chap Mei stuff. Those heads seem to be a bit larger than Joescale and might work better on the big Juggie body than a regular Joe body.

Check out the Corps! heads too (the newer ones). They're just a tad larger then ARAH heads.

I can check tonight...but I'm thinking Visionaries or Sgt Savage heads would work alright with the larger juggy body

Hadn't thought about visionaries, but I might just have a Corps or Sgt. Savage head kicking around to try.

I'm now pondering...

- R

What about the bald CORPS! head that was being used for a lot of Vulture customs a year or 2 back?

It's nice and generic with a screaming mouth. Make a nice psycho.

Viperlord is funny I was thinking that same head,with some added hair it would look like a really pissed off looking juggs ready to just stomp somebody.

I think he's trying to get away from Juggernaut though with the figure otherwise why change the head? Am I right? Canadians can be so confusing what with their proper grammer and friendly demeanor

I didn't think about Sgt. Savage. That scale might actually work better than a CORPS! or Chap Mei head. And give you a better quality sculpt to boot.

I think he's trying to get away from Juggernaut though with the figure otherwise why change the head? Am I right? Canadians can be so confusing what with their proper grammer and friendly demeanor

Agreed - I want to make an entirely different character.

- R

I use these 5 inch knockoff wrestlers since they have funny expressions,

with a bit of dremlin then you can get it just right!

Are you talking about the MLS or SHS Juggy? Cause the SHS figure can be used with several diferent heads depending on the type of fig you want to make. I've done several juggy customs using older toybiz 5 inch figures.
What do you want to make? cause I have several heads that size.

Are you talking about the MLS or SHS Juggy? Cause the SHS figure can be used with several diferent heads depending on the type of fig you want to make. I've done several juggy customs using older toybiz 5 inch figures.
What do you want to make? cause I have several heads that size.

Super Hero Showdown, the 4" or so one. What heads do you have?

I am horrible with a dremmel, so a snap on stay on head would be best. (Or I'm gonna have to get VL to do the drilling for me...)

- R

Monster, normal, super what are you looking for??

Monster, normal, super what are you looking for??

Normal ish. Military. A brick wall kind of guy. Think Freight from Joe extreme.

- R