| JoeCustoms.com https://joecustoms.com/forums/ |
|
| Compatible arms for DTC Barrel Roll? https://joecustoms.com/forums/viewtopic.php?f=15&t=2219 |
Page 1 of 1 |
| Author: | DarkJedi [ Wed Sep 19, 2007 2:10 am ] |
| Post subject: | Compatible arms for DTC Barrel Roll? |
OK, I'm have been brainstorming to come up with something awesome for my JCW figure and have an idea. I know that many of you (carn, xhairs, etc) have posted some customs that have used the DTC Barrel Roll torso. I need to find some compatible arms that would fit. Right know I have a pair of single pack Dusty (tan/beige version) arms in place-but they are loose. Options? Suggestions? I'm trying to find something with bare arms, but I (shudder) might have to paint. I'd prefer not to, so at this point any suggestions of usable arms would be helpful... |
|
| Author: | Doc Rob [ Wed Sep 19, 2007 5:35 am ] |
| Post subject: | Re: Compatible arms for DTC Barrel Roll? |
Joe Colton from the Viper Lockdown set used DTC Barrel Roll arms. It's not listed at Yojoe in the parts section (I was surprised to see that) but they're identical (I know 'cause I'm using them and held the two side by side.) Needless to say they're an ideal fit. Just one idea to think of. 
|
|
| Author: | Mysterious Stranger [ Wed Sep 19, 2007 10:01 am ] |
| Post subject: | Re: Compatible arms for DTC Barrel Roll? |
Try the DTC Saw Viper arms too. I believe those are the same as the Barrel Roll/Colton arms. |
|
| Author: | Matthew [ Wed Sep 19, 2007 10:06 am ] |
| Post subject: | Re: Compatible arms for DTC Barrel Roll? |
Well, if the Colton arms are Barrell Roll, you could easily use VvV Wild Bill arms. They should fit. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|