| JoeCustoms.com https://www.joecustoms.com/forums/ |
|
| Figures with no screw in back... https://www.joecustoms.com/forums/viewtopic.php?f=15&t=34764 |
Page 1 of 1 |
| Author: | Rosey Joe [ Thu Aug 09, 2012 7:49 pm ] |
| Post subject: | Figures with no screw in back... |
For these figures with no screw in back and the waist is connected like the 93 vega, whats the best way to get them apart? |
|
| Author: | chad_ghost [ Thu Aug 09, 2012 10:07 pm ] |
| Post subject: | Re: Figures with no screw in back... |
I use an exacto knife and cut them at the seams. You should be able to start at the bottom of the torso where the pegs for the waist are. |
|
| Author: | Rosey Joe [ Fri Aug 10, 2012 1:28 am ] |
| Post subject: | Re: Figures with no screw in back... |
Okay yeah, i'll try that. Gracias. |
|
| Author: | nova [ Fri Aug 10, 2012 2:13 am ] |
| Post subject: | Re: Figures with no screw in back... |
I've had luck splitting figures like Dice or TJ Bang, by scoring the seam from armpit to belt on both sides, and then twisting the figure in the opposite direction. The internal stops can be enough to pop the torso appart. |
|
| Author: | Rosey Joe [ Fri Aug 10, 2012 9:36 pm ] |
| Post subject: | Re: Figures with no screw in back... |
Alright thx. I have a few of these. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|