Working on my Original 13 Kreons and found this cool custom backpack I want to use for Zap

http://stores.brickbrigade.com/-strse-1 ... Detail.bok


I know that it uses at least three Lego neck brackets, but not sure what other pieces might be used.

_________________

Could this be the vest itself?

http://www.brickforge.com/store/home.php?cat=465

_________________

Probably so. Not as concerned with the vest because I'll use a Lego neck bracket to hold the backpack in place.

_________________

As Chakacha said, I think it's the Vest. one of these bricks: http://www.bricklink.com/catalogItem.asp?P=32000, and then the 2 neck parts you identified.

_________________

I will be able to use a neck bracket to hold it the same way the vest is holding it. Here is the part that I am unsure of.

_________________

I suspect Yes... I dont have one of those 1x2 with 2 holes in hand, but Most Bricks have a small inner peg... I think its usually there to keep the brick from sliding side to side...but it also just happens to be the same diameter as the inner diameter on that neck bracket.

_________________

This what you have in mind?

http://www.brickset.com/parts/?part=3200026


If so, I think it'll work. Just had to talk it out

_________________

Nova is right about the peg diameter...looks like you have a recipe for success, sir!

_________________