JoeCustoms.com
https://joecustoms.com/forums/

Mean Dog measurement question
https://joecustoms.com/forums/viewtopic.php?f=15&t=40137
Page 1 of 1

Author:  chad_ghost [ Thu Feb 13, 2014 9:25 pm ]
Post subject:  Mean Dog measurement question

Does anyone have a Mean Dog that could get me these measurements?
Attachment:
meandog_meas.jpg
meandog_meas.jpg [ 22.92 KiB | Viewed 517 times ]

Author:  AdrienVeidt [ Fri Feb 14, 2014 5:59 pm ]
Post subject:  Re: Mean Dog measurement question

What's the bottom of the vertical wheel I-beam, the bottom of the MD itself, or the rim of the wheel?

Author:  AdrienVeidt [ Fri Feb 14, 2014 6:05 pm ]
Post subject:  Re: Mean Dog measurement question

I show the length of the fender at 8mm, from under the fender to the chassis bottom is 5mm.

Author:  chad_ghost [ Fri Feb 14, 2014 11:01 pm ]
Post subject:  Re: Mean Dog measurement question

AdrienVeidt wrote:
I show the length of the fender at 8mm, from under the fender to the chassis bottom is 5mm.

mm? Do you mean inches?

Author:  AdrienVeidt [ Sat Feb 15, 2014 10:09 am ]
Post subject:  Re: Mean Dog measurement question

Millimeters, yo. It's how Hasbro actually measured their stuff, and they're dead-on at 5 & 8mm each, so no need for converting or fudging to less-precise English.

Author:  Dusty79 [ Sat Feb 15, 2014 10:53 am ]
Post subject:  Re: Mean Dog measurement question

I don't use metric much, but millimeters are super small aren't they? Do you mean centimeters?

Author:  Anlaschog [ Sat Feb 15, 2014 10:56 am ]
Post subject:  Re: Mean Dog measurement question

AdrienVeidt wrote:
Millimeters, yo. It's how Hasbro actually measured their stuff, and they're dead-on at 5 & 8mm each, so no need for converting or fudging to less-precise English.

Your values are a bit off AV.
5mm is approx .2 inches and 8mm is about .32 inches.
I think you meant centimeters.
So 8cm is approximately 3.15" and 5cm is 1.97"

Author:  chad_ghost [ Sat Feb 15, 2014 11:58 am ]
Post subject:  Re: Mean Dog measurement question

Anlaschog wrote:
AdrienVeidt wrote:
Millimeters, yo. It's how Hasbro actually measured their stuff, and they're dead-on at 5 & 8mm each, so no need for converting or fudging to less-precise English.

Your values are a bit off AV.
5mm is approx .2 inches and 8mm is about .32 inches.
I think you meant centimeters.
So 8cm is approximately 3.15" and 5cm is 1.97"

Yep. My thoughts exactly.

Author:  AdrienVeidt [ Sat Feb 15, 2014 2:39 pm ]
Post subject:  Re: Mean Dog measurement question

I do the work, you guys are my Quality Assurance department.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/