| JoeCustoms.com https://joecustoms.com/forums/ |
|
| Rivets on new figure https://joecustoms.com/forums/viewtopic.php?f=15&t=47754 |
Page 1 of 1 |
| Author: | Nightwing1432 [ Mon May 11, 2020 11:26 pm ] |
| Post subject: | Rivets on new figure |
Ok this maybe the wrong place, but I hope someone has some experience with this. I just bought a black major build it yourself figure. I am not too worried about most of it, but the rivets. I thought (my bad) that it would have had directions/tip sheet, but no such luck. Has anyone put in new rivets? I can tap them with a drill bit but was hoping maybe someone has had experience and has some pro-tips before I just plunge in. Thank you |
|
| Author: | chad_ghost [ Wed May 13, 2020 1:45 am ] |
| Post subject: | Re: Rivets on new figure |
Are you on Facebook? There are some groups that have more specific information on this. |
|
| Author: | RangerMange [ Fri Jun 19, 2020 8:11 pm ] |
| Post subject: | Re: Rivets on new figure |
I used an ez rivet tool by beadsmith. I had to use a dremel to grind down the die that comes with it until it was in the right shape to not put pressure on the plastic. as far as i know that's the only way to do the arm rivets. or you can modify a pair of grommet pliers to the same effect. the rivets that come with the kit aren't the highest quality, they don't flare that far out, but they work. put too much pressure and you crack the elbows/shoulders. there's a little more info here: http://www.hisstank.com/forum/g-i-joe-t ... f-kit.html Also, on the snow serps, you have to use a very small gauge drillbit and drill the holes on the arms a little deeper or the rivet flare wont catch right. this was a factory error on the snow serpents. the invasors are easier and you don't have to drill. i'm no expert i just winged it with mine using whatever I had, there's people out there that are better at it than me. |
|
| Author: | RangerMange [ Fri Jun 19, 2020 8:12 pm ] |
| Post subject: | Re: Rivets on new figure |
chad_ghost wrote: Are you on Facebook? There are some groups that have more specific information on this. can you direct us to posts with said info? I can't find it. I would love to see some best practices type guide for the rivet install |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|