DarkJedi wrote:
Some of the helmets seem to be a little too high above their shoulders. It seems to give them a giraffe head.
Other than that, I'm seeing an amazing start.
Thanks! In terms of all the masks that were done, there are three or four that are a bit too high, gloria's, dusty's, and brad's, and maybe sly rax's. With most of the masks though it depends on how the torso is done, if removable vests and such are used it pushes the mask up. So, I tried to be careful with that, when a vest etc had to be there, I tried to make it as thin as possible and used green stuff instead of removable accessories a lot of the times. With the exception of the three I mentioned, I think the masks look pretty good. I think maybe a couple of the ones I pictured may be affected by camera angle possibly. Now as for the three I mentioned, I actually cut gloria's top portion off, sanded it shorter, cut the bottom in half and used the front piece to make it bigger and to fit further down on the figure. I've considered tying to cut down the brad and dusty one also. I know when others have used these masks there were comments on how they looked stretched up (and a few of the masks do), but the majority of the masks look good, especially when not pushed up with removable accessories between the mask and shoulders. Also most of them seem to be sculpted to fit the breaker type upper torso, other torsos just don't fit some of them as well, and also a couple benefited from heating up and bending out the front or back slightly.
Thanks for the comments fellas!